Dillenium Scanner

DILLENNIUM SCANNER 2999 - MY 2005

Cabin gommone with large sunbathing areas, T-top and a bow area that can be converted into a table with seating
for eight people. The unit is offered after an extensive refit stated to have been carried out in 2025, which involved
tubes, hull, cushions, electrical system, instrumentation, engine and outboard/rear leg.

The MerCruiser 6.2 MX MPI IE SmartCraft 320 hp has been rebuilt/revised and, according to the seller, shows about
two hours of testing after the interventions. The running-in period is still to be completed. On board: Garmin GPSMAP 923 with engine data, Fusion, electric anchor windlass with Quick counter meters, twin
batteries with Victron monitoring, refrigerator, carbon T-top, bow and stern sun canopies/tarps, small
cabin and electric WC.

Asking price: EUR 44,000. Data, equipment, work and documentation subject to verification during
viewing and sea trial.

Ice-grey colored tubes with carbon-effect fabric Top Novurania; Garmin GPSMAP 923 with engine data interface; integrated Fusion; electric anchor windlass and Quick counter meters; two new batteries, battery charger and Victron shunt; refrigerator; LED lights; two bilge pumps; new cushions; carbon T-top with stainless-steel structure; Sunshade covers/tarps for bow and stern; bench with backrest and storage compartment; cabin
with electric WC; table and bow sunbathing area; removable setup for auxiliary engine.
Fuel and water tanks declared as stainless steel, respectively 330 and 120 L.

*The listing indicates 8.20 m, while the yard model card states 7.85 m overall length: verify the measurement in the unit documents.

Scanner model data: nominal length 7.85 m, beam 3.00 m, CE category B, capacity 20 people
and maximum permitted power 450 hp. *Cruising speed 20-28 kn and max speed 38.5 kn detected by Pneumag on another unit with a 320 hp MerCruiser: indicative values, not measured on this boat. Sources:
scannerspain.com and pneumag.com.

Refit stated 2025: tubes replaced; hull restored to bare metal with epoxy primer and
anti-fouling; cushions redone; electrical system and instruments renewed; T-top
and covers/tarps installed; revised outboard/rear leg. Engine rebuilt/revised with crankshaft, injectors,
fuel and water pumps, raiser, sensors and accessory components declared new. Engine and outboard/rear leg cooling water intake in the hull.

This document in no case constitutes a contractual document. The listed price is to be considered net of Agency commission fees to be applied to the final closing value.
For any information please contact: REYACHT (Mattia L..) Cell: +39 3793456993